Filter
Top Products
7-4
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)
OL-20861-01
Chapter 7 Configuring Settings on the Cisco Unified IP Phone
Ethernet Setup Menu
• Unlocking and Locking Options, page 7-3
• Ethernet Setup Menu, page 7-4
• WLAN Setup Menu, page 7-7
• IPv4 Setup Menu Options, page 7-10
Ethernet Setup Menu
The Ethernet Setup menu provides options for viewing and making a variety of network settings.
Table 7-1 describes these options and, where applicable, explains how to change them.
For information about how to access the Ethernet Setup menu, see the “Displaying a Setup Menu”
section on page 7-2.
For information about the keys you can use to edit options, see the “Editing Values” section on page 7-3.
Note The Ethernet data fields are overwritten when a VPN connection is established.
Ta bl e 7-1 Et he rne t Se t up Menu Options
Option Description To Change
IPv4 Setup In the IPv4 Setup configuration submenu, you can do the
following:
• Enable or disable the phone to use the IP address that
is assign by the DHCP server.
• Manually set the IP Address, Subnet Mask, Default
Routers, DNS Server, and Alternate TFTP servers.
For more information on the IPv4 address fields, refer to
Table 7-3.
Scroll to IPv4 Setup and press the
Select button.
MAC Address Unique Media Access Control (MAC) address of the
phone.
Display only—Cannot configure.
Domain Name Name of the Domain Name System (DNS) domain in
which the phone resides.
1. Set the DHCP Enabled option to
No.
2. Scroll to the Domain Name
option, press the Select key, and
then enter a new domain name.
3. Press the Apply softkey.