Filter
Top Products
A-4
ADMINISTRATION REQUIREMENTS
TRUNK GROUP Page 1 of 5
Group Number:
Group Name:
Direction:
Dial Access?
Queue Length:
Comm Type:
(number assigned)
MEGACOM 800 DNIS
Group Type: tie SMDR Reports? y
COR: 1
TAC: 189
1-way in
y
0
voice
Outgoing Display? y
Data Restriction? n
Busy Threshold: 60
Night Service: ____
Internal Alert? n
Incoming Destination: ____
TRUNK PARAMETERS
Trunk Type(in/out):
Outgoing Dial Type:
wink/auto
_______
Incoming Rotary Timeout(sec): 5
Incoming Dial Type: tone
Disconnect Timing(msec): 500
Digits: _____
Digit Treatment: __________
Used for DCS? n
ACA Assignment? n
Short Holding time(secs.): 10
PBX ID: 1
Long Holding Time(hours): 1
Short Holding Threshol: 15
Baud Rate: ______
Synchronization: ______ Duplex: _____
Incoming Dial Tone? _
Answer Supervision Timeout: ___
Maintenance Test? y
Suppress # Outpulsing? n
Figure A-4. Trunk Group Screen, Page 1 (MEGACOM 800 DNIS)
At the 4ESS, and for SDN service applications, this trunk type is called PBX (typically 2-way trunks).
However, both 1-way incoming and 1-way outgoing trunk groups may be translated. At the 4ESS,
these PBX trunk types are translated for DTMFWK type signaling. The Digits and Digits
Treatment fields may or may not be translated depending on the local numbering plan and other
addressing requirements or restrictions for a 4ESS toll office.