Filter
Top Products
7-16
ADMINISTRATION OPTIONS AND REQUIREMENTS — SYSTEM 85
Procedure 262 Word 1: ISDN Board Parameters
Procedure 262 is used in System 85 R2V4 and Generic 2 to administer DMI-MOS (ANN35) for
other service/facility options (DMI-MOS/ISDN-PRI only). Figure 7-5, Procedure 262 Word 1: ISDN
Board Parameters, depicts procedure 262, word 1.
ENHANCED MODE - PROCEDURE: 262, WORD: 1
ISDN BOARD PARAMETERS
EQUIPMENT LOCATION
1.
2.
3.
4.
Module:
Cabinet:
Carrier:
Slot:
PRI PARAMETERS
5.
6.
7.
Interface Type:
Facility Test Code:
Terminal Endpoint Identifier:
PRI LAYER 2 PARAMETERS
8.
9.
Timer T203:
Timer T200:
Counter N200:
Counter K:
10.
11.
Connected to CC0 ON-LINE
enter command:
Figure 7-5. Procedure 262 Word 1: ISDN Board Parameters
Fields 1-4
V4 Only
Assigns the circuit pack to an equipment location. These include the module
number (0 through 30), cabinet number (0 through 7), DS1/MFAT carrier number
(0 through 3), and slot number (5 or 18).
NOTE: Entries for these four fields are the default values from translating a 5
in field 14 of procedure 260. These entries should always be correct.