Filter
Top Products
7-90
ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Field 8 Assigns or not assign the trunk group to SMDR record keeping. Field encodes and
their descriptions are:
0
1
2
Trunk group usage not applicable for SMDR recording
Trunk group usage will be recorded by SMDR
Trunk group usage will be recorded, account code is required
Fields 9-11 Not used for ISDN applications.
Field 12 This field is only applicable when SMDR is being used, and then only to change the
default SMDR timer value. Field encodes represent intervals in 1-second
increments. The range is 1 through 99 with dash (–) being the default timer value
of 6 seconds.
Field 13 Administer the optional transmission loss assignments. The encode translated
depends on the network configuration and service application. Field encodes and
their corresponding loss plan are listed as follows:
0
1
2
3
4
5
6
7
8
The Digital FIXED Loss Plan
ISL Tie Trunk
EIA Tie Trunk
NOTE: This is the recommended option for Speedial Access Connections to
a 4ESS.
ISL Digital Central Office
EIA Digital Central Office
Digital Toll Office
Analog Toll Office
AUTOPLEX NETWORK Interface V
AUTOPLEX NETWORK Interface Y
Refer to chapter 4, The Digital Loss Plan, for a description of the digital loss plan
and to table 4-2, Digital Loss Plan (Port-to-Port Losses), in this same chapter for a
list of port-to-port loss values.
Fields 14-16
These fields are ignored by ISDN software. Either encode (0 or 1) is satisfactory.
Procedure 103 Word 1: Network Trunk Group Translations
This procedure is used to translate the trunk group network parameters. Figure 7-43, Procedure 103
Word 1: Network Trunk Group Translations, depicts this procedure.