Filter
Top Products
ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
7-69
Procedure 262 Word 3: ISDN-PRI Codeset Map Assignments
Depending on the terminating switch it may be necessary to administer a Codeset Map Assignment
and convert from one codeset or codepoint to a different codeset or codepoint. This administration
assignment is required for ISDN-PRI links originating on a Generic 2 and terminating on a System 85
R2V4. Figure 7-31, Procedure 262 Word 3: ISDN-PRI Codeset Map Assignments (Generic 2), depicts
this procedure.
ENHANCED MODE - PROCEDURE: 262, WORD: 3
ISDN LINK PARAMETERS
EQUIPMENT LOCATION
1.
2.
3.
4.
5.
Module:
Cabinet:
Carrier:
Slot:
Circuit:
6.
7.
Codeset Map Number:
Hyperactivity Management:
Connected to CC0 ON-LINE
enter command:
Figure 7-31. Procedure 262 Word 3: ISDN-PRI Codeset Map Assignments (Generic 2)
Fields 1-4 Assigns a particular equipment location/circuit pack to be given a codeset map
number. Table 7-8, Codeset Differences, depicts the permitted equipment ranges.
Field 5
Assigns whether the circuit pack is BRI or PRI. dash (–) is appropriate for ISDN-
PRI.
Field 6 Assigns a codeset map number. The permitted range is (0 through 15). Number
selection is arbitrary, however; a suggestion is start with 0 and select higher numbers
as needed.
When Codeset map numbers are translated they are assigned on a D-Channel Group
number basis. All ISDN-PRI circuits within a D-Channel Group must be
administered with the same Codeset Map Number.