Filter
Top Products
7-114
ADMINISTRATION OPTIONS AND REQUIREMENTS — SYSTEM 75
The DS1/DMI trunks are defined by using the TRUNK GROUP screen. This screen is somewhat
equivalent to System 85 procedure 260, field 14, encode 1. Figure 7-59, Trunk Group Screen, Page
1 (DMI), depicts this procedure.
TRUNK GROUP
Page 1 of 5
Group Number:
Group Name:
Direction:
Dial Access?
Queue Length:
__
OUTSIDE
two-way
y
0
Group Type:
CALL
COR:
1
Outgoing Display?
Busy Threshold:
dmi
n
60
SMDR Reports?
y
TAC:
___
Night Service:
____
Incoming Destination:
____
TRUNK PARAMETERS
Trunk Type(in/out):
Outgoing Dial Type:
Digit Treatment:
ACA Assignment?
____________
tone
__________
n
Incoming Rotary Timeout(sec):
Incoming Dial Type:
Disconnect Timing(msec):
Digits:
Long Holding Time(hours):
Short Holding Threshold:
5
tone
500
_____
1
15
Short Holding Time(secs.):
10
Bit Rate:
Incoming Dial Tone?
1200
y
Synchronization:
async
Duplex: full
Maintenances Test?
y
Answer Supervision Timeout:
___ Supress # Outpulsing?
y
Figure 7-59. Trunk Group Screen, Page 1 (DMI)
This screen is similar to the one for administering tie trunks. The primary difference is related to
data capabilities ( Bit Rate, Synchronization, and Duplex). ( Bit rate and data rate mean the same
for System 75 applications.)