Filter
Top Products
7-120
ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 1
SYNCHRONIZATION PLAN Page 1 of 1
SYNCHRONIZATION SOURCE (DS1 circuit pack location)
Primary:
___
Secondary:
___
DS1 CIRCUIT PACKS
Location Name
Slip
Location
Name
Slip
___
___
___
___
___
___
___
___
___
___
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_
_
_
_
_
_
_
_
_
_
___
___
___
___
___
___
___
___
___
___
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_______________
_
_
_
_
_
_
_
_
_
_
Figure 7-62. Synchronization Plan Screen
Primary The 3-character location of the circuit pack that is the primary synchronization
reference.
NOTE: The primary will be the DS1 circuit pack administered with slip
detection y. The location, name, and slip (that is, slip detection) fields list the
DS1 circuit packs that have been administered on the
DS1 CIRCUIT PACK screen.
The primary and secondary source must be selected from this list.
Secondary
The 3-character location of the circuit pack that is the secondary synchronization
reference. There is no requirement that a secondary source be provided. However,
it is a good practice.
The Command Line Feature set provides four executable commands for controlling
and monitoring synchronization. They are:
●
Disable
● Enable
●
Status
●
Set