Filter
Top Products
Programming Mode
1.
2.
3.
4.
5.
6.
Place the Programming Overlay over the dial pad of the system display phone
at extension 10 or 11—see “The Programming Overlays” earlier in this
chapter for more information.
To enter programming mode, press [
Feature ] [ 0 ] [ 0 ]. The display reads:
PROGRAM EXT 10
If you are programming from extension 11, “11” displays instead of “10.”
Press [
System Program ]. The display reads:
10 Enter name
This display is for the Extension Name Display feature. When you are
entering System Programming mode, skip it by moving on to Step 4.
Press [
System Program ] again. The display reads:
SYSTEM PROGRAM
Specify a programming procedure in one of two ways:
■
■
Direct Method to dial the code for that procedure. System
Programming procedures in this guide are identified by # and a
three-digit code (for example, System Date is (#101). This method is
best when you are using only a few procedures during a programming
session and you know the codes.
Cycle Method to cycle throuuh the procedures in numerical order.
Press [
Next Procedure ] and [ Prev Procedure ] to cycle forward and backward
through the programming procedures. This method is best when you
are using multiple procedures during a programming session, or if you
do not know the codes.
To exit programming mode, you can press [
Feature ] [ 0 ] [ 0 ] or lift the handset
off-hook, then place it back in the cradle.
NOTE:
You can talk on the phone while you program. This is useful if you need to talk
with someone at the AT&T Helpline about programming. However, you must
call before you enter programming mode, and you must use the handset to talk,
not the speaker and microphone.
Changing Programming Types
When you are in programming mode, you can move between System
Programming and Centralized Telephone Programming. To change to
Centralized Telephone Programming when you are in System Programming,
press [
Central Tel Program ]. To move back to System Programming when you are
in Centralized Telephone Programming, press [
Central Tel Program ] then
[
System Program ].
2-14 Programming