Filter
Top Products
Distinctive Ring (#308)
Description
This System Programming procedure determines whether calls should ring at a
standard device using the system’s distinctive ringing patterns—different
patterns for outside, intercom, and transferred calls—or whether all calls should
ring like outside calls.
Considerations
■
■
■
Change the setting to Not Active if a standard device such as a modem or
answering machine does not pick up intercom or transferred calls.
If distinctive ring is set to Not Active for an extension where both a system
phone and a standard device are installed, the system phone continues to
use distinctive ringing, but all calls ring at the standard device using a
single ring burst.
The system does not pass distinctive ringing patterns generated by a PBX
or central office through to extensions (regardless of the setting for this
feature).
Valid Entries
1 = Active (outside calls are single ring burst) ✔
2 = Not Active (outside, intercom, and transferred calls are single ring burst)
Programming
To change the Distinctive Ring setting:
1.
Press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
] [
#
] [
3
] [
0
] [
8
].
2.
At the
Extension:
prompt, enter the number of the extension to be
programmed. For example, to program extension 42, press [ 4 ] [ 2 ].
3.
To activate or deactivate Distinctive Ring for the extension, press [
Next Data ]
until the appropriate value displays.
4. To program another extension, press [
Next Item ] or [ Prev Item ] until the correct
extension number shows on the display. Then repeat Step 3.
5.
Select another procedure or exit programming mode.
Distinctive Ring (#308)
5-57