Filter
Top Products
Touch-Tone Enable (F08)
Description
This feature lets a system phone user send touch-tone signals on an outside call
over a rotary line. For example, a user may need to dial touch-tone digits while
on a call to a bank-by-phone service.
Related Procedures
You must use
Dial Mode (#201)
to identify rotary lines to the system.
To activate this feature from within a number stored on an Auto Dial button
or as part of a Speed Dial number, press [
Transfer ] when storing the
number—see Special Dialing Functions.
Considerations
■
■
■
■
■
■
This feature is needed only when dialing on a rotary line.
Use Touch-Tone Enable only after a call is connected. For example, use
this feature after dialing a bank-by-phone service that requires you to dial
touch-tone digits.
You can program a Touch-Tone Enable button on a system phone to turn on
Touch-Tone Enable with one touch.
This feature is available only on system phones.
Programming
To program a Touch-Tone Enable button:
1.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ Central Tel Program ].
2.
Enter the number of the extension to be programmed with this feature.
3.
Press a programmable button.
4.
Press [ Feature ] [ 0 ] [ 8 ].
5.
Program another button for this extension or exit programming mode.
Using
From a system phone, press the programmed button or press [ Feature ] [ 0 ] [ 8 ]
when you need to dial touch-tone digits.
Touch-Tone Enable stays in effect until you hang up.
Touch-Tone Enable (F08)
5-145