Filter
Top Products
44
Push the air filter,
and pull it downward.
Front panel
(Lower)
Air filter knob
Filter holder
High Wall Type
(Model : 1H series)
• Push the projection at the center of the air filter.
• Undo the clip on the air filter, pull the air filter downwards while
pushing it towards the main unit side.
(Model : 2H series)
• Open the air inlet grille.
Lift the air inlet grille up in to the horizontal position.
• Take hold of the left and right handles of the air filter and lift it up
slightly, then pull downwards to remove it from the filter holder.
NOTE
• When cleaning the air filter, use a small brush or cleaning device.
If the air filter is heavily stained use a neutral detergent mixed with warm water.
• After washing the filter, rinse it out thoroughly and place in the shade to dry.
Do not expose to direct sun light.
• Once the air filter has dried, place the air filter back into the unit.
Floor Standing Cabinet Type
• Gently push down the upper part of the suction port, and then pull
towards you to remove it.
• Take out the air filter inside of the suction port.
Floor Standing Concealed Type
• Push down on the hook of the air filter on the front panel (Lower
side).
• Pull the air filter towards you to remove it.
Floor Standing Type
Removal / Attachment of air filter
• Pull the air filter towards you.
• To attach the air filter, insert it into the main body
and push.
Re-installing the air filter
• Insert the upper portion of air filter confirming alignment with the right and left edges of the indoor unit until it
is located.
• Close the air inlet grille.
If the FILTER lamp on the indoor unit is lit, push the FILTER button on the remote controller or the TEMPO-
RARY button on the indoor unit to turn off the lamp.
Cleaning of main unit / remote controller
CAUTION
• Wipe them with a soft and dry cloth.
• A cloth dampened with cold water may be used on the indoor
unit if it is very dirty.
• Never use a damp cloth on the main unit or remote controller.
• Do not use or leave a chemically treated duster on the unit for
long periods of time, as it may damage or alter the colour of
the unit surface.
• Do not use benzine, thinner, polishing powder, or similar
solvents for cleaning. These may cause the plastic surface to
crack or deform.
Do not use.
Polishing
powder
Benzene
Thinner
Chemical
floor-cloth
Cleaning the air inlet grille
1. Remove the air inlet grille.
Hold the two sides of the air inlet grille and open in an
upwards direction.
Move the center arm to the left and remove the grille.
2. Wash it with water using a soft sponge or towel.
(Do not use metallic scrubbing brush or other hard brushes.)
• Use of such hard objects will cause scratches on the
surface of the grille, and the metal coating to peel off.
• If very dirty, clean the air inlet grille with a neutral detergent
for kitchen use, and rinse it off with water.
3. Wipe the air inlet grille and allow to dry.
4. Fit the left and right arms of the air inlet grille to the shafts on
the two sides of the air conditioner and push in completely,
then push in the center arm.
5. Check that the center arm has been completely inserted and
then close the air inlet grille.
• Push the arrow locations (Four) at the bottom of the air
inlet grille to check whether the grill is completely closed.
Filter holder