Filter
Top Products
Chapter 4 Configuring Network Settings on the Cisco IP Phone
Modifying DHCP Settings
4-12
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
Using the Phone Configuration Web Page (Cisco IP Phone Models 7902G/7905G/7912G)
Procedure
Step 1 Open the Phone Configuration web page.
a. Open your web browser and enter the following URL, where IPaddress is the
IP address of your phone:
http://IPaddress
b. Press Enter.
The Phone Configuration web page appears.
Step 2 In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
Step 3 To disable DHCP, enter 0 in the DHCP field and click Apply.
On the Cisco IP Phone 7902G, you can also review phone settings using the IVR
system. See the “Using the Interactive Voice Response (IVR) System on the
Cisco IP Phone 7902G” section on page A-22.
Using the Phone’s Network Configuration Screen (Cisco IP Phone Models 7905G/7912G)
Procedure
Step 1 Press the Menu button.
Step 2 Use the Navigation button to select Settings, and then press the Select softkey.
Step 3 From the Settings menu, use the Navigation button to select Network
Configuration, and then press the Select softkey.
Step 4 From the Network Configuration menu, press **#.
If your phone displays “Enter Admin Password”, enter your password and then
press the Enter softkey.
Make sure that an unlocked padlock icon appears in the upper-right corner of your
LCD.