Filter
Top Products
Appendix A Additional Configuration Methods, Parameters, and Procedures
Configuration Parameters
A-20
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
Profile File Parameters
Table A-4 describes the parameters that you can configure through a phone’s
profile file only.
ConnectMode Connection mode of the
protocol used by the
Cisco IP Phone.
Bit map, as follows:
• Bit 0–29—Reserved for future use. Must be set
to 0.
• Bit 30 (mask 0x40000000)—If 1, enable
Cisco IOS Telephony Solution (ITS) support to
handle the differences between
Cisco CallManager and Cisco ITS. Cisco ITS
runs on an IOS router and is a subset of
Cisco CallManager. If you have Cisco ITS, refer
to the documentation for that product.
• Bit 31 (mask 0x80000000)—If 1, enable
downloading and processing of .cnf.xml
configuration file information sent by
Cisco CallManager.
NumTxFrames Not used.
UDPTOS UDP
1
IP ToS
2
. Determines
the precedence and delay of
sent IP packets.
Bit map value.
Use only the lower 8 bits. Upper bits should be set to
0.
The default setting is 0xB8.
MediaPort Port number where the
Cisco IP Phone sends and
receives RTP streams.
Enter an even number from 0 to 65535. Each
connection uses the next available even-numbered
port for RTP.
If set to 0, use the default value.
The default setting is 16384.
1. UDP = User Datagram Protocol
2. ToS = type of service
Table A-3 Audio Parameters (continued)
Parameter Description Usage