Filter
Top Products
Appendix A Additional Configuration Methods, Parameters, and Procedures
Configuration Parameters
A-16
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
Tone Parameters
Table A-2 describes the tone parameters that you can configure through a phone’s
profile file or through its Tone Parameters web page.
Nprintf IP address and port of a
server to which
Cisco IP Phone
troubleshooting messages
are sent.
Enter the extended IP address of the server to which
troubleshooting messages are sent and collected in a
log file.
The default value is 0, which specifies that no
messages are sent.
Note To collect troubleshooting messages, the
prserv.exe tool must be running on the server
specified with this parameter.
For more information about using Nprintf and
preserv.exe to collect troubleshooting information,
see the “Collecting Information for
Troubleshooting” section on page A-30.
TraceFlags Enables specific trace
features.
Bit map
Bit 0–31—Reserved for future use.
Should be set to zero (0). The default setting is
0x00000000.
1. CDP = Cisco Discovery Protocol
Table A-1 Network Parameters (continued)
Parameter Description Usage