Filter
Top Products
A-27
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
Appendix A Additional Configuration Methods, Parameters, and Procedures
Changing the Logo on the Cisco IP Phone LCD Screen
• Press 20 # to configure DHCP
• Press # to go to the extended menu
Step 3 Enter the voice menu code for the setting that you want to verify or change, and
then press #.
Note Use the * key to toggle between alphanumeric and numeric input mode.
For example, when you enter 905 #, the IVR prompts you for
alphanumeric input. When you enter 905 * #, the IVR prompts you for
numeric data.
Step 4 Follow the prompts and enter the appropriate values.
Step 5 The IVR repeats the value you entered, then prompts you to press one of the
following keys:
• 1=Change your entered value
• 2=Review your entered value
• 3=Save your entered value
• 4=Review the current saved value
Step 6 Hang up the phone. The phone resets.
Changing the Logo on the Cisco IP Phone LCD Screen
Note This section does not apply to the Cisco IP Phone 7902G.
When the Cisco IP Phone models 7905G and 7912G are not in use for a call, a
graphic appears on the LCD screen. Using TFTP configuring, you can change this
graphic to one that you provide. For example, you might change the graphic to
your company logo.