Filter
Top Products
Chapter 4 Configuring Network Settings on the Cisco IP Phone
Configuring CDP
4-32
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
Configuring CDP
You can disable or enable Cisco Discovery Protocol (CDP). CDP allows the phone
to be discovered by the CiscoWorks2000 network management system.
For more information about CiscoWorks2000, refer to the documentation
available at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/index.htm
Using the Phone Configuration Web Page (Cisco IP Phone Models 7902G/7905G/7912G)
Procedure
Step 1 Open the Phone Configuration web page.
a. Open your web browser and enter the following URL, where IPaddress is the
IP address of your phone
http://IPaddress
b. Press Enter.
The Phone Configuration web page appears.
Step 2 In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
Step 3 In the OpFlags field,
a. To enable CDP, change bit 6 to a zero (0).
b. To disable CDP, change bit 6 to a 1.
Using the Phone’s Network Configuration Screen (Cisco IP Phone Models 7905G/7912G)
Procedure
Step 1 Press the Menu button.
Step 2 Use the Navigation button to select Settings, and then press the Select softkey.