Filter
Top Products
Chapter 1 Introducing the ZyXEL Device
P-2612HNU-Fx User’s Guide
26
Refer to the Quick Start Guide for information on hardware connections.
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the passwords will be reset to the defaults.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.7 The WPS/WLAN Button
Use the WPS/WLAN button ( ) on the top of the device to turn the wireless
LAN off or on. You can also use it to activate WPS in order to quickly set up a
wireless network with strong security. Make sure the POWER LED is on (not
blinking) before using the WLAN button.
•Press the WLAN button for one second and release it. The WLAN LED should
change from on to off or vice versa.
• Press the WLAN button for five seconds to turn on WPS. See Section 7.5 on
page 143 for more on using WPS to configure your wireless clients.
USB Green/
Orange
On The ZyXEL Device recognizes a USB connection but there
is no traffic.
Blinking The ZyXEL Device is sending/receiving data to /from the
USB device connected to it.
Off The ZyXEL Device does not detect a USB connection.
Table 1 LED Descriptions
LED COLOR STATUS DESCRIPTION