Filter
Top Products
Chapter 7 Wireless LAN
P-2612HNU-Fx User’s Guide
135
Mode Select This makes sure that only compliant WLAN devices can associate with the
ZyXEL Device.
Select 802.11b/g/n to allow IEEE802.11b, IEEE802.11g and
IEEE802.11n compliant WLAN devices to associate with the ZyXEL Device.
The transmission rate of your ZyXEL Device might be reduced.
Select 802.11b/g to allow both IEEE802.11b and IEEE802.11g compliant
WLAN devices to associate with the ZyXEL Device. The transmission rate
of your ZyXEL Device might be reduced.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices
to associate with the ZyXEL Device.
Select 802.11n only in 2.4G band to allow only IEEE 802.11n compliant
WLAN devices with the same frequency range (2.4 GHz) to associate with
the ZyXEL Device.
Select 802.11n only in 5G band to allow only IEEE 802.11n compliant
WLAN devices with the same frequency range (5 GHz) to associate with
the ZyXEL Device.
Channel
Selection
Select this option and set the operating frequency/channel depending on
your particular region. Select a channel from the drop-down list box.
Scan Click this button to have the ZyXEL Device immediately scan for and select
a channel which is not used by another device.
Operating
Channel
The ZyXEL Device automatically scans for and selects a channel whenever
the device reboots or the wireless setting is changed. This is the channel
currently being used by your AP.
Intra-BSS
Traffic
Blocking
A Basic Service Set (BSS) exists when all communications between
wireless clients or between a wireless client and a wired network client go
through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-
BSS is enabled, wireless client A and B can access the wired network and
communicate with each other. When Intra-BSS is disabled, wireless client
A and B can still access the wired network but cannot communicate with
each other.
Check this to prevent wireless clients in this wireless network from
communicating with one another.
Output Power Set the output power of the ZyXEL Device in this field. If there is a high
density of wireless devices in an area, decrease the output power of the
ZyXEL Device to reduce interference with other wireless devices. Select
either Low, Med or High. See the product specifications for more
information on your ZyXEL Device’s output power.
HT
Parameters
HT (High Throughput) - Use the fields below to configure the 802.11n
wireless environment of your ZyXEL Device.
Table 24 Network > Wireless LAN > General (continued)
LABEL DESCRIPTION