Filter
Top Products
Chapter 5 WAN Setup
P-2612HNU-Fx User’s Guide
104
Note: You can configure up to eight (8) WAN services for each interface.
Figure 18 Network > WAN > Internet Connection
The following table describes the labels in this screen.
Table 12 Network > WAN > Internet Connection
LABEL DESCRIPTION
Interface This shows the name of the interface used by this connection.
A default name nas followed by a number (for example, nas1)
indicates the DSL interface. The name eth0.14 indicates the default
Ethernet WAN interface (the physical Ethernet WAN port).
The number after the dot (.) represents the VLAN ID number assigned
to traffic sent through this connection.
Description This is the service name of this connection.
1 and 2 or 0 and 1 are the default VPI and VCI numbers. The last
number represents the index number of connections over the same
PVC or the VLAN ID number assigned to traffic sent through this
connection.
Type This shows the method of encapsulation used by this connection.
Vlan8021p This indicates the 802.1P priority level assigned to traffic sent through
this connection. This displays N/A when there is no priority level
assigned.
VlanMuxId This indicates the VLAN ID number assigned to traffic sent through
this connection. This displays N/A when there is no VLAN ID number
assigned.
IGMP This shows whether IGMP (Internet Group Multicast Protocol) is
activated or not for this connection. IGMP is not available when the
connection uses the bridging service.
NAT This shows whether NAT is activated or not for this interface. NAT is
not available when the connection uses the bridging service.
Modify Click the Edit icon to configure the WAN connection.
Click the Remove icon to delete the WAN connection.
Add Click Add to create a new connection.