Filter
Top Products
Configuring Phone Lines and Calling Routing Behavior
Configuring SPA9000 FXS Ports
SPA9000 Voice System Administration Guide 57
4
Configuring SPA9000 FXS Ports
The SPA9000 FXS ports can be used to connect analog phones and fax machines
to the SPA9000 Voice System. A port also can be configured for a Streaming
Audio Server for Music On Hold. See Chapter 6, “Configuring Music on Hold.”
NOTE A fax machine can be connected to the Phone port of the SPA9000. Fax support
through an ITSP line requires a T.38 fax machine on both ends and the availability
of T.38 FAX relay through the ITSP. T.38 support is dependent on fax machine and
network / transport resilience. Linksys makes no guarantee with the use of this
product regarding fax transmission services
STEP 1 Start Internet Explorer, and then enter the IP address of the SPA9000. Click Admin
Login and then click Advanced.
STEP 2 Click Voice tab > FXS
N
, where N is the port number.
STEP 3 Scroll down to the Subscriber Information section, and then enter the following
settings:
• Display Name: Enter an extension number of name for the FXS 1 port, such as
Receptionist Area Fax Machine. You can use this extension number to add the
analog phone to the contact list, hunt groups, and shared line appearances.
• User ID: Enter a three- to four-digit extension number that is not is use by other
extension.
• If the device is a fax machine, disable echo cancelling. On the FXS N page,
Audio Configuration section, set the FAX Disable ECAN field to yes. Also make
sure that the Preferred Codec is set to G.711u (default setting).
STEP 4 Enter the Dial Plan settings, as needed. See “Configuring Dial Plans,” on page 66.
STEP 5 Click Submit All Changes.