Filter
Top Products
SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide 234
B
Attn-Xfer Act Code If the code is specified, the user must enter it before dialing
the third party for a call transfer. Enter the code for a call
transfer.
Modem Line Toggle
Code
Toggles the line to a modem.
Default: *99. Modem pass-through mode can be triggered
only by pre-dialing this code.
FAX Line Toggle Code Toggles the line to a fax machine.
Default: #99
Referral Services Codes These codes tell the SPA9000 what to do when the user
places the current call on hold by hook flash and is listening
to the second dial tone.
One or more *codes can be configured into this parameter,
such as *98, or *97|*98|*123, etc. Max length is 79 chars. Each
*code (and the following valid target number according to
current dial plan) entered on the second dial-tone triggers the
SPA9000 to perform a blind transfer to a target number that
is prepended by the service *code.
For example, after the user dials *98, the SPA9000 plays a
special dial tone called the Prompt Tone while waiting for the
user the enter a target number (which is checked according
to dial plan as in normal dialing). When a complete number is
entered, the SPA9000 sends a blind REFER to the holding
party with the Refer-To target equals to *98<target_number>.
This feature allows the SPA9000 to hand off a call to an
application server to perform further processing, such as call
park.
The *codes should not conflict with any of the other vertical
service codes internally processed by the SPA9000. You can
empty the corresponding *code that you do not want to
SPA9000 to process.
Default: blank