Filter
Top Products
Administering the SPA400 and Voice Mail Service
Configuring a SPA400 for Voice Mail Service
SPA9000 Voice System Administration Guide 115
5
NOTE Later you configure each client station for voice mail access to the
mail boxes that you create on this page.
STEP 6 Click Save Settings at the bottom of the page.
STEP 7 Restart the SPA400 by completing the following steps:
a. Click Administration tab > Reboot.
b. Click the Restart System button.
c. When the confirmation message appears, click OK. The SPA400 reboots.
d. When the
Reboot OK
. Go to Setup page? message appears, click OK.
STEP 8 To verify your progress, click the Status tab, and verify the following settings:
• USB status: Mount
• Voice mail status: OK
• SPA9000 Registration status: Registered
SPA400 Status
NOTE If the SPA registration status is not Registered, trying powering off the
SPA9000 and powering it on again.