Filter
Top Products
Administering the SPA400 and Voice Mail Service
Configuring a SPA400 to Interoperate with the SPA9000
SPA9000 Voice System Administration Guide 108
5
STEP 7 When the confirmation message appears, click OK.
STEP 8 When the Setup page reappears, verify that the Firmware Version number
matches the firmware version that you installed. You have successfully upgraded
the firmware.
SPA400 Main Page: Firmware Version
NOTE You may need to refresh your browser to display the updated banner
reflecting the new version number.
Configuring a SPA400 to Interoperate with the SPA9000
A SPA400 must be configured to register the SPA9000. To enable the
interoperation of the two devices, you need to enter corresponding information on
the SPA9000 Voice > Line page and on the SPA400 Setup > SPA9000 Interface
page. For voice mail service, additional entries are needed on the SPA400 Setup
> Voicemail Server page.
Be aware of the following factors:
• You need to complete this procedure for each SPA400, whether it is used as a
PSTN gateway or as a voice mail server.
• You need to configure a SPA9000 line interface for each SPA400. See
“Configuring a Line Interface for a SPA400 (PSTN or Voice Mail),” on page 60.