Filter
Top Products
SPA9000 Field Reference
Router Tab
SPA9000 Voice System Administration Guide 195
B
Router tab > Wan Setup page >
MAC Clone Settings section
Router tab > Wan Setup page >
Remote Management section
Secondary DNS The DNS server that is used by the SPA9000
NOTE When DHCP is enabled, you can enter the IP address
of a DNS server in addition to DHCP-supplied DNS servers.
When DHCP is disabled, enter the primary DNS server.
Default: 0.0.0.0
DNS Server Order The method for selecting the DNS server: Manual, Manual/
DHCP, and DHCP/Manual
DNS Query Mode The mode of DNS query: parallel or sequential
NOTE With parallel DNS query mode, the SPA9000 sends
the same DNS lookup request to all the DNS servers at the
same time, and the first incoming reply is accepted by the
SPA9000.
Default: parallel
Primary NTP Server The IP address or name of the primary NTP server
Secondary NTP Server The IP address or name of the secondary NTP server
DHCP IP Revalidate
Timer:
Enable MAC Clone
Service
Enable if you need to assign a different MAC address to the
SPA9000 via the Cloned MAC Address field.
Cloned MAC Address The MAC address that you need the SPA9000 to assume
Enable WAN Web Server Allows (yes) or prevents (no) access to the administration
web server from a computer that is not directly connected to
the SPA9000.
Default: yes
WAN Web Server Port The port that is used for WAN access to the SPA9000
Default: 80