Filter
Top Products
Configuring Your System for ITSP Interoperability
Network Address Translation (NAT) and Voice over IP (VoIP)
SPA9000 Voice System Administration Guide 52
3
STEP 3 Scroll down to the NAT Support Parameters section, and then enter the following
settings to enable and support the STUN server settings:
• Handle VIA received: yes
• Handle VIA rport: yes
• Insert VIA received: yes
• Insert VIA rport: yes
• Substitute VIA Addr: yes
• Send Resp To Src Port: yes
• STUN Enable: Choose yes.
• STUN Server: Enter the IP address for your STUN server.
Voice tab > SIP > NAT Support Parameters
STEP 4
Click Voice tab > Line
N
, where N is the number of the line interface.
STEP 5 Scroll down to the NAT Settings section.
• NAT Mapping Enable: Choose yes.
• NAT Keep Alive Enable: Choose yes (optional).
Voice tab > Line N > NAT Settings
NOTE Your ITSP may require the SPA device to send NAT keep alive messages to
keep the NAT ports open permanently. Check with your ITSP to determine
the requirements.