Filter
Top Products
CONSIDERATIONS
If you plan to program other features when you program Automatic Line
Selection, you must program Automatic Line Selection first. If you are
already in the middle of a programming session, slide the T/P switch to the
center position and then back to P before programming this feature.
The Automatic Line Selection order is for only outside lines; the line
selection does not include intercom lines. However, if you remove all outside
lines from your Automatic Line Selection sequence, your system will select an
intercom line when you lift the handset. (See "Intercom Preference.")
If you don't program an Automatic Line Selection sequence, you will get
outside lines according to the sequence in which they are plugged into the
control unit.
ADMINISTRATION
PROGRAMMING
None
To program an Automatic Line Selection sequence for your voice terminal:
1
2
3
4
Slide the T/P switch to P.
The voice terminal rings every 5 seconds to remind you that you are programming and that you
cannot place or receive calls.
Dial **
Touch the line buttons in the order you prefer.
If you want to continue programming other feature, dial ** again
Otherwise slide the T/P switch to the center position.
HOW TO USE
When you want to place an outside call:
1
Lift your handset.
The MERLIN Pluss system connects you to a free line in the Automatic Line Selection sequence.
Auxiliary Lines
DESCRIPTION
The MERLIN Plus System provides an quxiliary jack, labeled "Aux", at the
top of each Line Module. This auxiliary line is bridged directly to outside Line
A or Line E, and does not go through the MERLIN Plus system control unit.
You can connect accessory devices to the system, and use these devices
independently of the system.. These devices include:
5-14 Section 5: Reference