Filter
Top Products
Quick Reference Guide to System Administration
The following table is a quick guide to administration procedures for the
MERLIN
®
Plus Communications System. If you need more information on a
procedure than the table gives you, look up the procedure in Section 5,
"Reference."
Before you perform the steps given for any procedure, you first have to enter
administration mode as follows:
1
Slide the T/P switch on the left side of the console to P.
The red lights next to the line buttons go on steady.
The green lights next to the line buttons begin flashing.
The console rings every five seconds to remind you that it's in programming mode.
2
Touch Administer.
The red lights go on steady next to Administer and Restrict.
All other lights go off, and the ringing stops.
NOTE:
If you are performing several of these procedures in one
administration session, you don't have to leave administration mode
after each one. Simply dial the appropriate code or touch the
appropriate button to begin the next procedure.
When you finish administering the system, leave administration mode as
follows:
1
Slide the T/P switch to the center position.
2
Change any voice terminal (telephone) button labels and any entries on
forms or directories to reflect the administration or programming changes
you've made.
Administration Procedure Do This
Specify toll-prefix or area-code-only dialing.
1
Enter Administration mode.
2
Dial the appropriate code:
*36 for toll-prefix dialing
*37 for area-code-only dialing.
3
Touch Administer.
The console beeps twice.
4 Leave Administration mode.
1
Enter administration mode.
2 Dial the appropriate code:
*38 for Touch-Tone dialing
*39 for rotary (pulse) dialing.
3
Touch Administer.
The console beeps twice.
4 Leave administration mode.
Specify Touch-Tone or rotary (pulse) dialing.
Quick Reference Guide to System Administration 6-1