Filter
Top Products
ADMINISTRATION
If your responsibilities do not include system administration, skip this
information.
1
Enter administration mode by sliding the T/P switch to P and touching
Administer.
2
Dial *57.
The green light goes on next to those lines that cannot be bridged or monitored.
3
If you want to change the Privacy setting of either Line A or Line E,
touch the line button until the green light next to it shows the setting you
want:
Geen light on = the line is private
Green light off = the line can be monitored
4
Touch Administer.
The console beeps twice.
5
Leave administration mode by sliding the T/P switch to the center
position.
PROGRAMMING
None
HOW TO USE
None
Program
DESCRIPTION
CONSIDERATIONS
By using the Test/Program switch and following the instructions listed below,
you can program features that you have selected for your voice terminal onto
available buttons.
There are several programmable features that you can use with either a button
or a dial code. Therefore, if you have a limited number of available feature
buttons, you may choose to use a dial code rather than program any of those
features onto your voice terminal.
If you make a mistake when programming a button, simply touch the button
again and redial the programming code and all required numbers.
If you want to change the feature assignment on a programmable button, use
the procedure listed on the next page.
5-56
Section 5: Reference