Filter
Top Products
Entering Administration Mode
To enter administration mode:
1
2
Slide the T/P switch on the left side of the console to P (down).
The green lights next to the line buttons begin flashing.
The console rings every five seconds to remind you that it's in programming mode.
Touch Administer, or dial #01.
The green lights go off.
The red lights go on steady next to Administer and Restrict.
NOTE:
A 10-button voice terminal doesn't have a button labeled
Administer. If you are using a 10-button voice terminal at the intercom
10 position, dial the 3-character code #01 in step 2.
Leaving Administration
Mode
Follow the boxed instructions below when you've finished an administration
session.
Leaving Administration Mode
To leave administration mode:
1 Slide the T/P switch on the left side of the console to the center
position.
The red lights next to Administer and Restrict go off.
The red light goes on next to a line button.
CENTRALIZED
PROGRAMMING
The people in your business may want to program their own voice terminals.
If so, the Training Manual, the User's Card, and Section 5, "Reference," all
include instructions for programming features onto voice terminals. Another
option available to you, as system administrator, is to program some or all
voice terminals from the administrator/attendant console. The boxed
instructions on the next page tell you how to do so. If you want two voice
terminals to have the same programming, the information under the next
heading, "Copy," tells you how to copy the programming from one voice
terminal to another.
3-8
Section 3: Administering the System