Filter
Top Products
Centralized Programming
COPY
To program voice terminals from the administrator/attendant console.
do the following:
1
2
3
4
5
Enter administration mode.
Touch the Auto Intercom button or dial the intercom number for the
first voice terminal you want to program.
Touch Conference.
Program the voice terminal according to the instructions in the Training
Manual or in Section 5, "Reference."
Leave administration mode, or select another voice terminal for
programming as follows:
a
b
c
d
Touch Conference.
Touch the Auto Intercom button or dial the intercom number for
the next voice terminal.
Touch Conference.
Program the voice terminal.
If you want to copy outside line assignments and programmable features from
one voice terminal ( the source ) onto the same buttons on another voice
terminal ( the target ), the boxed instructions on the next page tell you how to
do so. But first you should understand the following points about the Copy
procedure:
●
●
●
The Copy procedure copies the following from the source
—
—
—
—
—
—
Line assignments
Automatic line selection sequence
Call restrictions
Line ringing options
Personalized ring
Voice announcement enable/disable
The Copy procedure also copies most other programmable features from
the source onto the same buttons on the target, overwriting any
features previously programmed onto those buttons on the target.
The Copy procedure does not copy allowed list assignments.
Administration Preview 3-9