Filter
Top Products
Toll Prefix Setting
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
If your voice terminal does not respond when you slide the Test/Program
switch to T, check Section 7, "Troubleshooting," for possible causes and
recommended action.
In most telephone systems people must dial a toll prefix (a 1 or a 0) before
they dial an-area code and telephone number. When the MERLIN Plus
system is installed, it is set for dialing a toll prefix. If people in your system
don't need to dial a toll prefix, the system administrator must set the system
for dialing the area code only.
None
If your responsibilities do not include system administration, skip this
information.
To administer the system so people can dial an area code and telephone
number without a toll prefix:
1
2
3
Enter administration mode by sliding the T/P switch to P and touching
Administer.
Dial *37.
Leave administration mode by sliding the T/P switch to the center
position.
To change the system setting so that people must dial a toll prefix before an
area code and a telephone number:
1 Enter administration mode by sliding the T/P switch to P and touching
Administer.
2
Dial *36.
3
Leave administration mode by sliding the T/P switch to the center
position.
5-76
Section 5: Reference