Filter
Top Products
ADMINISTRATION The system administrator can program features onto individual voice terminals
by using the Centralized Programming feature. (See "Centralized
Programming.")
Individual feature programming codes are provided in programming
instructions in the reference description for each programmable feature and in
Section 6, "Quick Reference Guides."
To program a feature onto your voice terminal:
PROGRAMMING
HOW TO USE
1
2
3
4
5
6
7
Type or print on the button label strips all the names of the features you
want to program. Then insert the labels into the appropriate slots on your
voice terminal.
Slide the T/P (Test/Program) switch on the left side of the voice terminal
to the P (Program) position.
The red lights next to all voice terminal buttonsgo on steady.
The green lights next to the buttons begin flashing.
The voice terminal rings every 5 seconds to remind you that you are programming and that you
cannot place or receive calls.
Touch the first button you want to program.
Consult the programming instructions in each individual feature's entry in
this section or use the codes listed in Section 6, "Quick Reference
Guides," of the System Manual, to determine the feature's programming
code. (You can also refer to the MERLIN Plus System User's Card for
programming codes.)
Dial the required programming code and any other numbers required.
Touch the second button you want to program and dial the required
programming code and numbers. Continue to follow this procedure for all
other buttons you want to program.
Slide the T/P switch to the center position.
Recall
DESCRIPTION If you are on a PBX or Centrex system, you can use the Recall feature when
directions tell you to include a switchhook flash.
CONSIDERATIONS
By touching the Recall button, you will get one of the following:
● A new dial tone.
● Access to Custom-calling services.
MERLIN Plus System Features
5-57