Filter
Top Products
*
INITIAL CONDITIONS
2. Initial specific energy.
Repeat this data line as often as necessary to define initial specific energy in various elements or element
sets.
Data lines for TYPE=SPUD EMBEDMENT:
First line:
1. Element set or element number.
2. Spud can embedment,
.
Repeat this data line as often as necessary to define initial embedment for various elements or element
sets.
Data lines for TYPE=SPUD PRELOAD:
First line:
1. Element set or element number.
2. Spud can preloa d,
.
Repeat this data line as often as necessar y to define initial preload for various elements or element sets.
Data lines for TYPE=STRESS if the G EOSTATIC, REBAR, SECTION POINTS, and USER
parameters are omitted:
First line:
1. Element number or element set label.
2. Value of first (effective) stress com ponent, axial force when used w ith the
*
BEAM GENERAL
SECTION or
*
FRAME SECTION options, or direct membrane force per unit width in the local
1-direction w hen used with the
*
SHELL GENERAL SECTION option.
3. Value of second stress component.
4. Etc., up to six stress com ponents.
Give the stress com ponents as defined for this element type in Part VI, “Elements,” of the
ABAQUS Analysis User’s Manual. Stress values given on data lines are applied uniformly and
equally over all integration points of the elem ent. In any elem ent for which an
*
ORIENTATION
option applies, the s tresses must be given in t he local system (“Orientations,” Section 2 .2.5 of the
ABAQUS Analysis User’s Manual).
Repeat this data line as often as necessary to define initial stresses in various elements or element sets.
Data lines for TYPE=STRESS, GEOSTATIC:
First line:
1. Element number or element set label.
2. First value of vertical component of (effective) stress.
9.18–14
ABAQUS Version 6.1 Module:
ID:
Printed on: