Filter
Top Products
*
INCIDENT WAVE PROPERTY
9.12
*
INCIDENT WAVE PROPERTY: Define the geometric data describing an incident
wave .
The preferred interface for defining the geometric data for an incident wave is the
*
INCIDENT WAVE
INTERACTION PROPERTY option used in conjunction with the
*
INCIDENT WAVE INTERACTION
option. The alternative interface uses the
*
INCIDENT WAVE PROPERTY option to define the geom etric
data for incident waves. The alternative interface will be removed in a subsequent release.
Each
*
INCIDENT WAVE option must refer to an
*
INCIDENT WAVE PROPERTY definition. The
*
INCIDENT WAVE PROPERTY option must be followed by the
*
INCIDENT WAVE FLUID PR OPERTY
option, which defines the fluid properties used in the incident wave loading.
Products: ABAQUS/Standard ABAQUS/Explicit
Type: Model data
Level: Model
References:
•
“Acoustic loads,” Section 27.4.5 of the ABAQUS Analysis User’s Manual
• *
INCIDENT WAVE
• *
INCIDENT WAVE FLUID PROPERTY
Required parameter:
NAME
Set this parameter equal to a label that will be used to refer to the incident wave property in the
*
INCIDENT WAVE option.
Optional parameter:
TYPE
Set TYPE=PLANE (default) to specify a planar incident wave.
Set TYPE=SPHERE to specify a spherical incident wave.
Data lines to define an incident wave property:
First line:
1. X-coordinate of , the posit ion of the incide nt wave standoff point.
2. Y-coordinate of
, the position of the incident wave standoff point.
3. Z-coordinate of
, the position of th e incident wave standoff point.
9.12–1
ABAQUS Version 6.1 Module:
ID:
Printed on: