3D Connexion Version 6.6 Two-Way Radio User Manual


 
*
STEADY STATE TRANSPORT
parameter and overrides the automatic calculation of the damping factor based on a value of the
dissipated energy fraction.
INERTIA
Include this parameter to indicate that inertia effects must be accounted for.
Set INERTIA=NO (default) to ignore inertia effects.
Set INERTIA=YES to include inertia effects.
LONG TERM
Include this parameter to indicate that there is no viscoelastic or viscoplastic materi al response
during this step. The solution must be based on the long-ter m elastic moduli if the material
description includes viscoelastic material properties or be based on the long-term response of the
elastic-plastic network alone if the tw o-layer vis coplastic mate rial model is used.
MULLINS
Include this parameter when the Mullin s effect material model is used to indic ate how the Mullins
effect should be applied over the step.
Set MULLINS=RAMP to indic ate that the Mullins effect should be ramped up over the time
period of the current step.
Set MULLINS=STEP (default) to indicate that the Mullins effect should be applied
instantaneously at the beginning of the current step.
PASS BY PASS
Include this parameter to indicate that a quasi-steady-state (pass-by-pass) procedure will be used to
obtain the steady-state solutio n.
If this parameter is omitted, the ste ady-state solution w ill be obtained directly.
STABILIZE
Include this parameter to use automatic stabilization if the problem is expected to be unstable due
to local instabilities. Set this parameter equal to the dissipated energy fraction of the automatic
damping algorithm (see “Solving nonlinear problems,” Section 7.1.1 of the ABAQUS Analysis
User’s Manual). If this parameter is omitted , the stabilization algorithm is not activated. If this
parameter is included without a specified value, the default value of the dissipated energy fraction
is
. If the FACTOR param eter is used, any value of the dissipated energy fraction will be
overridden by the damping factor.
Data line to define a steady-state transpor t analysis:
First (and only) line:
1. Initial time increment. This value will be modified as re quired if the automatic time stepping
scheme is used or will be used as the constant time increment if the DIRECT parameter is used.
2. Time period of the step.
3. Minim um tim e increment allowed. Only used for automatic time increm entation. If
ABAQUS/Standard finds it needs a smaller time increment than this value, the analysis is
18.35–2
ABAQUS Version 6.1 Module:
ID:
Printed on: