Filter
Top Products
*
REBAR LAYER
17.11
*
REBAR LAYER: D efine layers of reinforcement in membrane, shell, surface, and
continuum elements.
This option is used to define one or multiple rebar layers in membrane, shell, and surface elements. It must
be used in conjunction with the
*
MEMBRANE SECTION, the
*
SHELL SECTION, or the
*
SURFACE
SECTION option. Rebarlayers in solid (continuum) elements can be defined by embedding a set of surface or
membrane elements with rebar layersin a set of host continuum elements through the use ofthe
*
EMBEDDED
ELEMENT option.
Products: ABAQUS/Standard ABAQUS/Explicit
Type: Model data
Level: Part, Part instance
References:
•
“Defining reinforcement,” Section 2.2.3 of the ABAQUS Analysis User’s Manual
•
“Embedded elements,” Section 28.4.1 of the ABAQUS Analysis User’s Manual
• *
EMBEDDED ELEMENT
• *
MEMBRANE SECTION
• *
SHELL SECTION
• *
SURFACE SECTION
Optional parameters:
GEOMETRY
Use this parameter to specify the type of rebar geometry.
Set GEOMETRY=CONSTANT (default) if the rebar spacing in the element is constant. The
spacing is given as a length measure on the data lines.
Set GEOMETRY=ANGULAR if the rebar spacing increases linearly as a function of the
distance measured from the axis of revolution in a cylindrical coordinate system. The spacing is
given as an angular spacing in degrees on the data lines. A cylindrical or ientation system must be
defined if this option is used w ith three-dimensional membrane, shell, or surface elem ents.
Set GEOMETRY=LIFT EQUATION if the rebar spacing an d orientation within the element is
determined by the tire “lift” equation. The rebar parameters are defined with respect to the uncured
or “green” tire configuration, and the lift equation maps the rebar parameters to the cured tire
configuration. The spacing is given as a length measure on th e data lines. A cylindrical orientation
system must be defined if this option is used with three-dimensional membrane, shell, or surface
elements.
17.11–1
ABAQUS Version 6.1 Module:
ID:
Printed on: