Filter
Top Products
*
INITIAL CONDITIONS
Data lines for TYPE=RELATIVE DENSITY:
First line:
1. Node set or node num ber.
2. Initial relative density.
Repeat this data line as often as necessary to define initial relative density at various nodes or node sets.
Data lines for TYPE=ROTATING VELOCITY:
First line:
1. Node set or node num ber.
2. Angular velocity about the axis defined from point a to point b, where the coordinates of a and
b are given below.
3. Global X-component of translational velocity.
4. Global Y-component of translational velocity.
5. Global Z-component of translationa l velocity.
Second line:
1. Global X-component of point a on the axis of rotation.
2. Global Y-component of point a on the axis of rotation.
3. Global Z-component of point a on the axis of rotation.
4. Global X-component of point b on the axis of rotation.
5. Global Y-component of point b on the axis of rotation.
6. Global Z-component of point b on the axis of rotation.
Repeat this pair of data lines as often as necessar y to define the angular and translational velocities at
various nodes or node sets.
Data lines for TYPE=SATURATION:
First line:
1. Node set or node num ber.
2. Saturation value, s. Default is 1.0.
Repeat this data line as often as necessary to define saturation at various nodes or node sets.
Data lines for TYPE=SOLUTION if the USER and REBAR parameters are omitted:
First line:
1. Element number or element set label.
2. Value of first solution-dependent state variable.
3. Value of second solution-dependent state variable.
4. Etc., up to seven solution-dependent state variables.
9.18–12
ABAQUS Version 6.1 Module:
ID:
Printed on: