Filter
Top Products
*
JOINT PLASTICITY
7. First field variable.
8. Second field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than two):
1. Third field variable.
2. Etc., up to eight field variables per line.
Repeat this s et of data lines as often as necessary to define the plastic behavior as a function of
temperature and other predefined field variables.
Data lines for TYPE=CLAY:
First line:
1. , undrained shear strength of the clay.
2. a, hardening parameter.
3. b, hardening param eter.
4. c, hardening param eter.
5. Temperature.
6. First field variable.
7. Second field variable.
8. Third field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than three):
1. Fourth field variable.
2. Etc., up to eight field variables per line.
Repeat this s et of data lines as often as necessary to define the plastic behavior as a function of
temperature and other predefined field variables.
Data lines for TYPE=MEMBER:
First line:
1. , com pressive capacity.
2.
, tensile capacity.
3.
, horizontal capacity.
4.
, moment capacity.
5. Temperature.
6. First field variable.
7. Second field variable.
8. Third field variable.
10.3–2
ABAQUS Version 6.1 Module:
ID:
Printed on: