3D Connexion Version 6.6 Two-Way Radio User Manual


 
*
REBAR
2
1
L
ocal beam
s
ection axes
X
X
1
2
Rebar
Figure 17.10–1 Rebar location in a beam section.
Data lines to define isoparametric rebar in three-dimensional shell elements:
First line:
1. Element num ber or name of the element set that contains these rebar.
2. Cross-sectional area of each rebar.
3. Spacing of the rebar in the plane of the shell. The default is 1.0.
4. Position of the rebar in the shell section thickness direction. This value is given as the distance
of the reb ar from the middle surface of the shell, positive in the direction of the positive normal
to the shell. This value is modified if the NODAL THICKNESS parameter is included w ith
the
*
SHELL SECTION option of the underlying shell element.
5. Edge number to which the rebar are parallel in the element’s local (isoparametric) coordinate
system. See Figure 17.10–2.
Repeat this data line as often as necessar y. Each line defines a layer of rebar.
Data lines to define isoparametric rebar in three-dimensional membrane elements:
First line:
1. Element num ber or name of the element set that contains these rebar.
2. Cross-sectional area of each rebar.
3. Spacing of the rebar in the plane of the membrane. The default is 1.0.
4. Edge number to which the rebar are parallel in the element’s local (isoparametric) coordinate
system. See Figure 17.10–2.
Repeat this data line as often as necessar y. Each line defines a layer of rebar.
17.10–3
ABAQUS Version 6.1 Module:
ID:
Printed on: