Filter
Top Products
*
SURFACE INTERACTION
18.49
*
SURFACE INTERACTION: Define surface interaction properties.
This option is used to create a surface interaction property definition. The surface interaction properties w ill
govern any contact interactions that reference this surface interaction.
Products: ABAQUS/Standard ABAQUS/Explicit
Type: Model data in ABAQUS/Standard; Model or history data in ABAQUS/Explicit
Level: Model in ABAQUS/Standard, Model or Step in ABAQ US/Explicit
References:
•
“Surface properties for ABAQUS/Explicit contact pairs,” Section 29.4.2 of the ABAQUS A nalysis
User’s Manual
•
“Mechanical contact properties: overview,” Section 30.1.1 of the ABAQUS Analysis User ’s Manual
•
“Contact pressure-overclosure relationships,” Section 30.1.2 of the ABAQUS Analysis User’s Manual
•
“Contact damping,” Sectio n 30.1.3 of the ABAQUS Analysis User’s Manual
•
“Frictional behavior,” Section 30.1.5 of the ABAQUS Analysis User ’s Manual
•
“User-defined interfacial constitutive behavior,” Section 30.1.6 of the ABAQUS A nalysis User’s Manual
•
“Breakable bonds,” Section 30.1.9 of the ABAQUS Analysis User’s Manual
•
“Thermal contact properties,” Section 30.2.1 of the A BAQ US Analysis User’s Manual
•
“Electrical contact properties,” Section 30.3.1 of the ABAQUS Analysis U ser’s Manual
•
“Pore fluid contact properties,” Section 30.4.1 of the AB AQU S Analysis User’s Manual
Required parameter:
NAME
Set this parameter equal to a label that will be used to refer to this surface interaction property.
Use this label on the INTERACTION parameter of the
*
CONTACT PAIR option (for an
ABAQUS/Standard contact analysis or an ABAQUS/Explicit analysis using the contact pair
algorithm) or on the data line of the
*
CONTACT PROPERTY ASSIGNMENT option (for an
ABAQUS/Explicit analysis using the general contact algorithm) to assign this surface interaction
property to a contact interaction.
Optional parameters:
PAD THICKNESS
This parameter applies only to ABAQUS/Explicit analyses using the contact pair algorithm.
18.49–1
ABAQUS Version 6.1 Module:
ID:
Printed on: