Filter
Top Products
*
SLOAD
18.20
*
SLOAD: Apply loads to a substructure.
This option is used to activate a substructure load case defined by the
*
SUBSTRUCTURE LOAD CASE
option.
Product: ABAQUS/Standard
Type: History data
Level: Step
References:
•
“Using substructures,” Section 10.1.1 of the ABAQUS Analysis User’s Manual
• *
SUBSTRUCTURE LOA D CASE
Optional parameters:
AMPLITUDE
Set this parameter equal to the name given to an amplitude defined by the
*
AMPLITUDE
option (“Amplitude curves,” Section 27.1.2 of the ABAQUS Analysis User’s Manual). This
amplitude defines the time variation of the load case (
*
SUBSTRUCTURE LOAD CASE)
magnitude throughout the step. If this parameter is omitted, the default amplitude is that defined in
“Procedures: overview,” Section 6.1.1 of the ABAQUS Analysis User’s Manual, for the particular
procedure used in the step.
OP
Set OP=MOD (default) to modify or add to the currently active
*
SLOADs.
Set OP=NEW if all existing
*
SLOADs applied to the m odel should be rem oved and new ones
possibly defined.
Data lines to define the loading:
First line:
1. Element number or element set name. The elements must be substructures.
2. Load case name (as defined on the associated
*
SUBSTRUCTURE LOAD CASE option).
3. Load magnitude. This magnitude is a multiplier for the load case magnitude defined under
the
*
SUBSTRUCTURE LOAD C ASE option. It can be adjusted throughout the step by the
amplitude specification in the usual way.
Repeat this data line as often as necessar y to define the loadings on the substructures.
18.20–1
ABAQUS Version 6.1 Module:
ID:
Printed on: