Filter
Top Products
*
PERMEABILITY
Data lines to define fully saturated isotropic permea bility (TYPE=ISOTROPIC):
First line:
1. k.(UnitsofLT
−1
.)
2. Void ratio, e.
3. Temperature,
.
4. First field variable.
5. Second field variable.
6. Etc.,uptofivefieldvariables.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than five):
1. Sixth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of da ta lines as often as necessar y to define the variation.
Data lines to define fully saturated orthotropic permeability (TYPE=ORTHOTROPIC):
First line:
1. . (U n its of LT
−1
.)
2.
.
3.
.
4. Void ratio, e.
5. Temperature,
.
6. First field variable.
7. Second field variable.
8. Third field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than three):
1. Fourth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of da ta lines as often as necessar y to define the variation.
Data lines to define fully saturated anisotropic permeability (TYPE=ANISOTROPIC):
First line:
1. . (U n its of LT
−1
.)
2.
.
3.
.
4.
.
5.
.
16.6–2
ABAQUS Version 6.1 Module:
ID:
Printed on: