Filter
Top Products
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-69-
TABLE RM-BW
SPEED DIAL MODE (CHANGE/REVIEW)
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE REPTEnter the Speed Dial Mode
At the >MODE prompt, enter R E P T CR.
2 REnter the station port number for which the speed
dial number will be programmed
Press
(00 ~ 19)
Station Port Number
NOTE: If programming system speed dial, enter
port number
0 0.
3 REnter Speed Dial Memory Location to be Programmed
A) Press
10 ~ 49 Station
60 ~ 99 System
Memory
location
(current memory will display)
N
Nothing in
memory
4 R1) To enter speed dial number (20 digits max)
Press
N
. . . . . . . . . .
20-digit number
2) To enter chain dial number
Press A . . . . . . . . . . . .
17-digit number
System speed dial location (90 ~ 99)
. . . . . . . . . .
New speed dial number
(Refer to Digital or Electronic Telephone User Guide for
information regarding chain dialing.)
Special Entries: F=Flash; P=1.5 or 3-sec Pause (Prog. 12);
L=10-sec Pause; N=Clear Memory.
5 RTo store data, press CR
NOTE: If program entry is not correct,
CR
will not
respond. To try again, press
DELETE CR
at the same time.
6 >MODETo Exit the Speed Dial Mode
Press Q U I T CR.
B) Press SPACE to review each memory location or go to Step 4.
Special code entry: I = Intercom
H = Hold
C = Conference