Filter
Top Products
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-51-
To store data, press CR.
To exit this program, press # # CR.
TABLE RM-AY
PROGRAM 50-2
LCR HOME AREA CODE
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 50
P50
Enter Program Number 50
3 P50 2 NNNEnter the number 2. The system will display the last area code
programmed. Refer to the System Record Sheet and change
if required.
Press CR.
4 To Exit Program/Store Data P50 2 NNN
P50 ##
P
A)
B)
To store data, press CR.
Continue returning to step 3 until all data for this program has
been entered.
To exit this program, press # # CR.
TABLE RM-AZ
PROGRAM 50-31 ~ 35
LCR SPECIAL CODES
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 50
P50
Enter Program Number 50
3 P50 31 NNNNRefer to the System Record Sheet and enter 31 ~ 35 as required.
Example: 31, enter 3 1.
System will display previously programmed number. Refer to the
System Record Sheet and change if required.
Press CR.
4 To Exit Program/Store Data P50 31 NNNN
P50 ##
P
A)
B)
C)