Filter
Top Products
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-55-
TABLE RM-BF
PROGRAM 53
LCR SCHEDULE ASSIGNMENT
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 53
P53
Enter Program Number 53
3 P53 1
Press CR.
7 P53 ##
P
To Exit Program/Store Data
A)
B)
C)
Data was stored when pressing CR in step 6.
Continue returning to step 3 until all data is entered
for this program.
To exit this program.
Press # # CR.
Define Route Plan Number
Refer to the System Record Sheet and enter the route
plan number (1 ~ 8).
Example: Route Plan 1, enter 1.
4 P53 11Define Schedule Number
Refer to the System Record Sheet and enter the required
schedule number (1 ~ 3).
Example: Schedule 1, enter 1.
5 P53 110 0000 0800
P53
The system will display the previously selected time for
the route plan number (step 3) and the schedule number (step 4).
Refer to the System Record Sheet and change the time if required.
Example: Change to 0800. Enter 0 8 0 0.
Press CR and repeat steps 3, 4, and 5 for all plans/schedules.
NOTE: Enter time using 24-hour format:
H H M M.
6 P53 111 NNNN 12
P53
Enter the route plan number as defined in step 3.
Enter the schedule number as defined in step 4.
Refer to the System Record Sheet and enter the required
station group number (1 ~ 4).
Example: Group 1, enter 1.
Priority Class Assignment
The system will display the previously entered route definition
numbers (reference
Refer to the System Record Sheet and enter required
route definition numbers (1 ~ 4) and press CR.
Example: Enter 1 and 2 CR.
Enter Code Number 0
Program 54 ).
Continue to repeat steps 3, 4, and 6 until all plans/schedules
are entered.