Toshiba DK 16 Telephone User Manual


 
INSTALLATION-PERIPHERALS
SECTION 100-816-207
MARCH 1993
7-25
Line 03 returns intercom dial tone to caller after
two ring cycles (5 ~ 6 seconds).
Caller dials 13.
After 48 seconds from start of call, station 13
answers.
Printout B prints after station 13 answers the call
at 4:32.
NOTE:
If Program 60-2 is set for 10 seconds, MSS
will not print if the call is answered within 10
seconds from when the caller receives dial
tone.
PRINTOUT B
03 MSS 04:32 00:00:48 00:05 13
EXAMPLE 3—DISA Outgoing CO Line Call
NOTE:
DISA CO line calls print out as DISA.
Call Sequence C
Outside caller rings CO line 01 (line 01 is pro-
grammed as DISA).
Line 01 returns intercom dial tone after two ring
cycles (5 ~ 6 seconds).
Caller dials 703 to access CO line 03 (outgoing).
Caller dials the DISA security code and receives
CO dial tone.
Caller dials the telephone number and con-
verses when the call is answered.
Caller hangs up.
The call releases, and Printout C prints after the
call disconnects at 12:22.
NOTES:
1. If the CO provides the auto release (AR)
signal (see Program 15), the call discon-
nects when either party hangs up. A “*” will
print out following the CO line number if
the call is disconnected by the AR signal.
2. If the auto release signal is not returned,
the CO lines will remain seized until the
DISA disconnect timer releases the call
(approximately five minutes).
PRINTOUT C
Auto Release Signal:
03*DISA 12:22 00:02;01 (outgoing)
01 DISA 12:22 00:02;01 (incoming)
calling through the system CO-to-CO.
NOTE:
MSS will print only on DISA calls that are
answered 10 seconds or 1 second (see Pro-
gram 60-2) after the DK dial tone is sent to the
calling party. If set for 10 seconds and the call
is answered before 10 seconds, the call will
register as a normal incoming call and the
MSS/transfer portion of the call will not print
out.
6.02 Figure 7-19 shows a sample SMDR printout
and describes the contents of each column of the
printout. The following examples show several call
record samples and describe the sequence of
events which occurred to generate the call records.
NOTE:
SMDR printout “time of day” and day/month/
year (DD/MM/YY) is the same as the system
clock time/date. SMDR DD/MM/YY will print
out each time 50 call records are generated.
SMDR PRINTOUT EXAMPLES
Direct Inward System Access (DISA) CO Lines
NOTE:
DISA station calls print out as MSS.
EXAMPLE 1—Ring, No Answer DISA Call
Call Sequence A
Outside caller rings CO line 03 (CO line 03 is
programmed as a DISA line).
Line 03 returns intercom dial tone to caller after
two ring cycles (5 ~ 6 seconds).
Caller does nothing.
After 32 seconds, call is disconnected.
Printout A prints after disconnect at 4:59.
PRINTOUT A
03 MSS 04:59 00:00:32 00:06
EXAMPLE 2—DISA Internal Station Call
Call Sequence B
Outside caller rings CO line 03 (CO line 03 is
programmed as a DISA line).