Filter
Top Products
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-38-
TABLE RM-AH
PROGRAM 60
SMDR OUTPUT/ACCOUNT CODE DIGIT LENGTH
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter PROGCR
2 P 60
P60
Enter Program Number 60
CR
3B P60 3 1
P60
Press
Allow SMDR printout.
System will print out "1" if incoming and outgoing calls will be
printed on SMDR. A "0" will be printed out if only outgoing calls
will be printed.
3C P60 4 06Set Account Code Digit Length
Enter: Item code 4.
The system will display the number of digits allowed in the
account code. The default is 06.
Refer to the System Record Sheet and enter the required number
of digits (04 ~ 15) and press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
Refer to the System Record Sheet and change (to 1 or 0), if
required, and press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3D P60 5 0
4 To Exit Program/Store Data
Press # # CR.
3E
P60 6 NNNN
P60 6 NNNN
P60 ##
P
SMDR Toll Calls Only
The system will display the presently selected feature (0 ~ 5).
The default is 0. Refer to the System Record Sheet and enter the
required feature code and press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
Enter DISA ID Code
System will display last entered ID code number. Default = Blank.
Refer to the System Record Sheets, and enter a new code if
desired, and then press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
.
.
Enter: Action code 3.
Enter: Action code 5.
Enter: Item code 6.
3A P60 21SMDR Threshold Time
Enter: Item code 2.
The system will display either "0" or "1". "0" indicates that the
threshold time is set at 0.1 seconds. "1" indicates 10 seconds.
The default is "1".
Refer to the System Record Sheet, and enter the correct digit—
if it is not already being displayed—and then CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3F P60 7 13Credit Card Call Digit Length
Enter: Item code 7.
The system will display the current digit length.
Refer to the System Record Sheet, and enter the desired length,
01 ~ 30 digits, and then CR. Example: 13 digits; enter 1 3 CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.