Filter
Top Products
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-63-
NOTES:
1. To cancel a message set via Mode 95, use Mode 97 with any message number in step 4 and skip
step 5.
2. [M] represents the message entered.
3. DKT = digital telephone; EKT = electronic telephone.
TABLE RM-BP
MODE 97
REMOTE CALLING STATION MESSAGING (ADD/CHANGE)
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE MESGEnter the Message Mode
At the >MODE prompt, enter M E S G CR.
2 m 97To Add a Message
3
Set the terminal keyboard to lower case (caps lock off) and
enter m 9 7.
4
m97 XXX
5
Enter: p (p = page command and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system messages).
6
To Add a Message
To Exit the Message Mode m 0
q
>MODE
Enter X X X (XXX = station number for which the message will
be set and stored).
m97 XXX p
NOTE:
To store system message change permanently, DKT or EKT XXX
must be station assigned to port 00.
Set the terminal keyboard to upper case and enter message
(alphanumeric, 32 characters max.). New message displays as
it is entered.
At any time, enter m 0 q (lower case).
NOTE:
Enter “m” at anytime it is desired to start over in this procedure.
7
m97 XXX p
[M]
To Set the Message on the DKT/EKT LCD
Set the terminal keyboard to lower case and enter p m 0.
m97 XXX p
[M] p
m 0
(or change a previously stored message)
Zero