Filter
Top Products
,...................................
A=m : to select boundary class l...... default
121: class 2
131: class 3
cl
4 :class4
0 5 :class5
cl 6 : class 6
171 : class 7
q
: class 8
Description
Programming
Dial (11).
“Toll Restriction”, if it is programmed, prohibits
CO
Operator Calls. However, the desired
extensions can be permitted to call to CO
Operator by programming a boundary number
of service class.
1.
2.
“Operator Class” will be displayed.
CO Operator Calls are allowed at all the
extension from service class 1 to the same
service class number as the programmed
boundary number, but are prohibited at the
extensions which has not done the above setting.
Example : If Boundary Class 4 is set for
All extension numbers for which service classes 1 to
4 have been assigned, then CO operator calls are
allowed, but extensions assigned service class 5 to
3.
4.
5.
Press the NEXT button.
“Boundary Class-l” will be displayed and
“1 ” will blink.
Dial the boundary class number (1 through 8).
Press the MEMORY button.
The LCD will stop blinking.
To return to the initial program mode, press
the END button.
8 will be prohibited from placing CO operator calls.
(See the table below.)
Boundary Class Number
Service Class of
Toll Restriction
A : CO Operator Calls are allowed.
D : CO Operator Calls are denied.
Programming table
See
page 7-5.
See “Service Class Assignment of Toll
Restriction” on page 3-67.
3-19