Filter
Top Products
To set
i . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . until the desired DTMF receiver appears
:.....................................................
To confirm
until desired mode appears
Enable
. . . . . . . . . . . . . . . . . .
default
Disable
1
A= q
: to assign to same of all 3 receivers
111 : receiver
1
121: receiver
2
: receiver 3
Dial any extension (100 through 199) and listen for that extension to ring,
Description
DTMF (Dual Tone Multi Frequency) Receiver
enables tone telephones to dial within the system.
To check the DTMF Receivers, activate the DTMF
Receivers at a time and confirm if the receiver can
receive tone singals.
Operation at Extension Connected to Jack
Number 1.
To Remove DTMF Receive 2 and 3:
1. Set the System Program Switch on the
KX-Tl23211 to the “PITS” position.
2. Dial (30) to enter the DTMF mode.
“DTMF-R Selection” will be displayed.
3. Press the NEXT button.
“DTMF-R NO?+” will be displayed.
4. Press the NEXT button, twice, or dial (2).
“DTMF-R2 : Enable” will be displayed.
5. Press the SELECT button to change to
“Disable”.
“DTMF-R2 : Disable” will be displayed.
6. Press the MEMORY button.
7. Press the NEXT button, or press the SELECT
button and then dial (3).
“DTMF-R3 : Enable” will be displayed.
6. Press the SELECT button to change to
“Disable”.
9. Press the MEMORY button.
10. Press the END button to return to the initial
program mode.
11. Set the System Program Switch to the
“SET” position.
Confirmation of DTMF Receiver 1:
1. Set the DIALING MODE (located on the rear of
KX-T123230 or KX-T123235) switch to the TONE
position.
2. Set the POWER FAILURE (located on the rear of
KX-Tl23230 or KX-T123235) switch to the ON
position.
3. Dial the extension number (100 through 199).
4. If DTMF Receiver is bad, do the following
procedure for removing the DTMF Receiver
after the next step on this section.
5. Set the POWER FAILURE Switch-to the OFF
position.
l
To check DTMF Receiver 2, remove DTMF
Receiver 1 and confirm that DTMF Receiver 2 is
good by the procedures of “To Remove DTMF
Receiver 1 and 3” and “Confirmation of DTMF
Receiver 2”.
.
c
l
To check DTMF Receiver 3, remove DTMF
Receiver 1 and confirm that DTMF Receiver 3 is
good by the procedures of “To Remove DTMF
Receiver 1 and 2” and “Confirmation of DTMF
Receiver 3”.
6-4